™
SmartLight
Clip
Productivity Lamp
Model: VC02
VC02-MAN-Rev6.indd
1
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
READ ALL INSTRUCTIONS BEFORE USING
Important Safeguards
DANGER:
• To avoid electrocution, do not operate this lamp near water.
WARNING:
• Do not use with power supply voltage other than 120 VAC.
• Do not defeat the the safety purpose of the polarized plug. A polarized plug
has two blades with one wider than the other. The wider blade is provided
for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
• To prevent risk of shock or personal injury when cleaning these lamps, make
sure you have turned off and unplugged them, and allow sufficient time for
the bulbs to cool.
• Do not operate lamp in close proximity to flammable or combustible vapors,
such as aerosol spray products, or where oxygen is being administered.
• Do not cut or shorten the power cord.
• Do not block vents. Vents are neccessary for proper function of the
electronic ballast blocking them may cause overheating of the electronics
and increase risk of fire.
• The bulb in this product contains a trace amount of mercury, a chemical
known to the state of California to cause birth defects or other reproductive
harm. This substance may also cause injury if inhaled or ingested.
• Some people may experience light sensitivity to fluorescent lighting.
Discontinue use if you experience any discomfort.
• Certain drugs may induce light sensitivity (e.g., anti-depressants) which may
result in discomfort or a level of hyperactivity. Consult with your health care
provider before using this product.
• If you have a pre-existing eye condition, consult with your health care
provider before using this product.
CAUTION:
• For indoor use only.
• Always unplug lamp before performing bulb replacement or installation.
• This lamp is not for use with light dimmers, timers, motion detectors,
voltage transformers or extension cords.
• This product may cause interference with radios, cordless telephones
or devices that use a wireless remote control, such as televisions. If
interference occurs, move the product away from the device, plug the
3
VC02-MAN-Rev6.indd
3
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
Important Safeguards — continued
CAUTION: — continued
product or device into a different outlet or move the lamp out of the line of
sight of the remote control receiver.
• If this lamp has been damaged in any way, for example, the power supply
cord or plug has been damaged, liquid has been spilled or objects have
fallen onto the lamp, the lamp has been exposed to rain or moisture, the
lamp does not operate normally or has been dropped, it should not be
operated. There are no user serviceable parts in this lamp.
• Unplug lamp during lightning storms or when unused for extended periods
of time.
• Use only the type of bulb and maximum wattage indicated by Verilux.
• Use the vertical shaft to lift the lamp.
• Protect the power cord from being walked on or pinched, particularly at the
plugs, convenience receptacles and the point where the power cord exits
the the lamps.
• Never cover the lamp or place anything on top of it when it is in operation.
• Do not use solvents or cleaners containing abrasives, or ammonia based
cleaners on this product.
• After cleaning the lamp, all moisture should be properly wiped away and
dried before restoring power.
• Do NOT use lubricating agent in assembly; please see troubleshooting
section if you are having difficulty assembling your lamp.
• Disconnect lamp before performing alignment activity.
• Dispose of bulbs per local regulations. For more information on clean-up
and disposal, see www.epa.gov/cfl.
SAVE THESE INSTRUCTIONS
4
VC02-MAN-Rev6.indd
4
1/30/13 12:40 PM
Getting Started
Main Parts and Controls
D. Bulb
E. On/Off Switch
F. Optix® Lens Cover
A. Lamp Head
B. Gooseneck
C. Clip
A
E
F
D
B
C
5
VC02-MAN-Rev6.indd
5
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
Why the Name “Productivity Lamp”?
When it comes to maximizing work, study or task time, the
SmartLight™ is the perfect partner. This lamp is designed with Verilux’s
patented Natural Spectrum Daylight, a type of full spectrum lighting that
replicates key wavelengths of natural daylight, to help you read faster
with greater comprehension, work longer without eyestrain, and improve
productivity and focus.
Research using full spectrum lighting in a school setting resulted in
significantly greater student achievement when compared to other
light sources. And naturally lit study environments have also proven
to positively impact students’ abilities to understand study materials,
resulting in increased math and reading test scores.
The SmartLight combines more than 50 years of research to
scientifically tune light to the needs of the human eye. At home, college
or office, the SmartLight is the perfect productivity partner.
Scientifically Tuned to the Human Eye™
Verilux Natural Spectrum light is just the right kind of illumination, easily absorbed by the
eye, efficiently cueing the body to improve mood, energy and function while reducing light
sensitivity, eyestrain and fatigue.
Verilux Natural Spectrum light illuminates in the specific scotopic range, with the right mix
of color and intensity to better stimulate your eyes’ photoreceptors, known as “cones”
and “rods.” Like daylight, this spectrally enhanced light allows optimum visual stimulation
without oversaturation or glare.
Natural Spectrum® Light
Intense Artificial Light
Intense Broad
Spectrum Light
Verilux Natural
Irritated
Eye
Comfortable
Spectrum Light
Eye
Lens
Rods
Cones
Rods
Lens
Rods
Cones
Rods
Relaxed Smaller
Pupil
Strained Larger
Pupil
Oversaturated
Well-Stimulated Photoreceptors
Under-Stimulated Rods Cones
Scattered Light Rays (Glare) Slow Visual Processing
Organized Light Rays Aid Visual Processing
Measuring Verilux light with an advanced scotopic light meter quickly shows why Natural
Spectrum Illumination is superior. With a high scotopic content and fewer unwanted light
rays, all of the eye’s photoreceptors are properly stimulated. This relaxes the eye muscles
and protects against potentially harmful over stimulating light that irritates the eye and slows
visual processing. It’s just the right light in just the right amount to maximize your enjoyment
and productivity.
6
VC02-MAN-Rev6.indd
6
1/30/13 12:40 PM
Bulb Replacement Instructions
Removal
1. Unplug lamp from power source and,
if necessary, allow time for the bulb to
cool.
2. Hold the metal lamp shade and turn
it counterclockwise. (See Fig. 1.)
Carefully pull the shade over the bulb
and set the shade aside.
Fig. 1
3. Hold the lamp and twist the bulb
counterclockwise, as you would a
conventional light bulb.
Installation
1. Unplug lamp from power source.
2. Hold the lamp and align the two pins
on the bottom of the bulb with the
corresponding openings in the bulb
base. (Either pin in either opening is
fine. See Fig. 2.)
Fig. 2
CACUATUIOTNIO: N: Always unplug lamp before performing bulb
replacement or installation.
7
VC02-MAN-Rev6.indd
7
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
Troubleshooting
Before requesting service on your Verilux® lamp, please:
• Make sure all power connectors, cords and plugs are inserted fully and
securely.
• Be sure the bulb is securely seated into the socket. (See page 7.)
• Make sure there is power to the wall outlet, or try another one.
PROBLEM
CHECK
SOLUTION
Has the plug come
loose?
Insert plug securely into wall outlet.
Is the bulb old?
Light Won’t
Come On
Check bulb for blackening/darkening at bottom of spiral where it joins the
base (an indicator of bulb life) and replace bulb.
Be sure the bulb is securely seated in the socket. Repeat the bulb
Is the bulb connected
securely into socket?
CAUTION:
installation process.
DISCONNECT LAMP FROM OUTLET
PRIOR TO REPEATING THE BULB INSTALLATION PROCESS.
Sometimes when a new bulb is turned on for the first time the tubing will
darken, but this will fade after a few minutes.
With older bulbs, darkening of the tubing indicates end of bulb life. (This
doesn’t affect operation except to reduce the amount of light available,
since the phosphor in that area has become inactive.) Bulb replacement
is recommended.
Is the bulb new?
Is the bulb old?
Blackening/Darkening
at Ends of Bulb
Insert plug securely into wall outlet.
Has the plug come
loose?
Be sure the bulb is securely seated into the socket. Repeat the bulb
Is the bulb connected
securely to the socket?
Light Flickers
CAUTION:
installation process.
DISCONNECT LAMP FROM OUTLET
PRIOR TO REPEATING THE BULB INSTALLATION PROCESS.
Is the lamp connected
to a dimmer switch?
Connect lamp plug only to wall outlet without dimmer switch.
Care and Cleaning
Your lamp is made from high-quality materials that will last for many
years with minimum care. You may want to periodically clean the lamp
using a mild non-abrasive cleaner and soft cloth. When cleaning, make
sure you have turned off and unplugged the unit and allowed sufficient
time for the unit to cool.
CAUTION: Do not use solvents or cleaners containing abrasives,
or ammonia-based cleaners.
CAUTION: After cleaning the lamp wipe away and dry all moisture
to restoring power.
8
VC02-MAN-Rev6.indd
8
1/30/13 12:40 PM
Component Order Form
Mail or Fax your order by using this form to:
Verilux, Inc., 340 Mad River Park, Waitsfield, VT 05673
Fax: 802-496-3105
Quantity
Price
$9.95
$6.95
Order Code
Product
CFS13GU24VLX 13 Watt Natural Spectrum® Bulb
Shipping & Handling
Subtotal
CT & VT Residents ONLY add 6% Sales Tax
Total Payment Enclosed
Payment Method:
❏VISA ❏MASTERCARD ❏DISCOVER ❏AMERICAN EXPRESS ❏CHECK
Name as it Appears on Card
_____________________________________________________________________
Credit Card Number _________________________________________________
Expiration Date______________________________________________________
Security Code (from back of card)______________________________________
Authorized Signature (credit card purchasers ONLY)
_____________________________________________________________________
Ship to Address _____________________________________________________
_____________________________________________________________________
_____________________________________________________________________
Phone Number ______________________________________________________
Email Address_______________________________________________________
9
VC02-MAN-Rev6.indd
9
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
10
VC02-MAN-Rev6.indd 10
1/30/13 12:40 PM
Warranty Registration
Thank you for purchasing this SmartLight Productivity Lamp. For your
warranty to be valid, this Warranty Registration MUST be completed
and mailed in a timely manner. Or, you can register your product online
Name ________________________________________________________
Address______________________________________________________
______________________________________________________________
______________________________________________________________
Phone Number _______________________________________________
Email Address: _______________________________________________
Model # ______________________________________________________
Date of Purchase (Month/Day/Year)____________________________
Please cut out form and send to:
VERILUX INC
PO BOX 451006
OMAHA NE 68145-5006
11
VC02-MAN-Rev6.indd 11
1/30/13 12:40 PM
Job#: 0.0637
Title: VC02 Manual Update
Version: Rev6
Date: 01/29/13
One-Year Limited Warranty
ATTENTION! ONCE OPENED, PLEASE DO NOT RETURN THIS PRODUCT TO THE
STORE WHERE IT WAS PURCHASED FOR REPAIR OR REPLACEMENT!
Customer Service Department at 800-786-6850 during normal business hours.
This limited warranty is provided by: Verilux, Inc., 340 Mad River Park, Waitsfield, VT 05673
Verilux warrants this product to be free from defects in material and workmanship for a
period of 1 year from the date of the original retail purchase from Verilux or an authorized
Verilux distributor. Proof of purchase is required for all warranty claims. During the
limited warranty period, Verilux Inc., will, at its option, repair or replace defective parts
of this product, at no charge to the customer, subject to these limitations: This limited
warranty does not include any postage, freight, handling, insurance or delivery fees. This
warranty does not cover damage, defect or failure caused by or resulting from accident,
external destruction, alteration, modification, abuse, misuse or misapplication of this
product.
This warranty does not cover damage to the product resulting from return shipping or
handling. Verilux recommends purchasing shipping insurance to protect your investment.
Return Authorization is required for all returns. To obtain a Return Authorization, please
contact the Verilux Customer Service Department at 800-786-6850.
If, during the first year of ownership, this product fails to operate properly, it should be
customer service representative at 800-786-6850.
Note: Verilux recommends using a quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components in any system. A quality
suppressor can eliminate the vast majority of failures attributed to surges and may be
purchased at electronics stores.
Due to ongoing improvements, actual product may have slight variations from the one described in this manual.
1-800-786-6850
Representatives are available Monday — Friday 9:00a.m to 5:00p.m. EST
340 Mad River Park, Waitsfield, VT 05673
Made in China
Printed in China for Verilux, Inc.
© Copyright 2013 Verilux, Inc. All rights reserved.
VC02-MAN-Rev6
VC02-MAN-Rev6.indd 12
1/30/13 12:40 PM
|